Xi'an Hani New Energy and Technology Co.,Ltd
0086 29 8536 7200 sales@hanrm.com

Products

Knowledge
Home > Industry News > Content

Flat Rolling

Source: | Updated: Dec 09, 2016

Flat rolling is the most basic form of rolling with the starting and ending material having a rectangular cross-section. The material is fed in between two rollers, called working rolls, that rotate in opposite directions. The gap between the two rolls is less than the thickness of the starting material, which causes it to deform. The decrease in material thickness causes the material to elongate. The friction at the interface between the material and the rolls causes the material to be pushed through. The amount of deformation possible in a single pass is limited by the friction between the rolls; if the change in thickness is too great the rolls just slip over the material and do not draw it in. The final product is either sheet or plate, with the former being less than 6 mm (0.24 in) thick and the latter greater than; however, heavy plates tend to be formed using a press, which is termed forming, rather than rolling.

Often the rolls are heated to assist in the workability of the metal. Lubrication is often used to keep the workpiece from sticking to the rolls.To fine tune the process the speed of the rolls and the temperature of the rollers are adjusted.


Feedback
Contact Us
Address: NO.67, Gaoxin Road, Xi'an 710075, Shaanxi P.R. China
Tel: 0086 29 8536 7200
Fax: 0086 29 8536 7200
E-mail:inquiry@hanrm.com
Home | Products | About Us | Technology | Industry News | Contact Us | Mobile | XML